Manitowoc Ice Ice Maker SN12 User Manual

Manitowoc SN12/SN20 Model Nugget Ice Machines

Cutter Head Replacement Instructions

1. Disconnect water supply.

2. Remove front panel.

3. Move toggle switch to CLEAN position after the 5 minute delay expires. The evaporator and float

chamber will drain.

4. Disconnect power at electrical disconnect.

WARNING

Disconnect power to the ice machine at the electrical disconnect, moving

the toggle switch to the off position will not disconnect line voltage.

5. Remove top, left and right side panels.

6. Remove ice chute assembly.

NOTE; if the ice wiper can not be hand removed; place the handle end of a screwdriver against the ice

wiper, then tap the screwdriver (counterclockwise) with a hammer to loosen the ice wiper from the

auger.

REMOVE COVER

REMOVE ICE DAMPER

REMOVE STRAINER

REMOVE ICE WIPER

REMOVE ICE CHUTE

LOOSEN HOSE CLAMP AND

DISCONNECT DRAIN LINE

Manitowoc Foodservice

2110 South 26^thStreet, P.O. Box 1720, Manitowoc, WI 54221-1720 USA

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879

000004021

Sheet 1 of 2

08/25/08