201
WELLS MANUFACTURING COMPANY
2 ERIK CIRCLE, P. O. Box 280
Verdi, NV 89439
Customer Service (775) 345-0444 Ext.502
fax: (775) 345-0569
OPERATION MANUAL
for
ELECTRONIC POP-UP TOASTERS
Models T-4C and T-4C 15A
and
BAGEL TOASTERS
Model BT-4C
Includes
INSTALLATION
USE & CARE
Model T-4C
IMPORTANT: DO NOT DISCARD THIS MANUAL
This manual is considered to be part of the appliance and is to be given to the OWNER or
MANAGER of the restaurant, or to the person responsible for TRAINING OPERATORS of
this appliance. Additional manuals are available from your WELLS DEALER.
THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR
INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any
questions concerning installation, operation or maintenance of this equipment.
p/n 40091 Rev. E
M201 020601 cps
Thank You for purchasing this
Wells Manufacturing Co.
TABLE OF CONTENTS
Electronic Pop-Up Toaster.
WARRANTY
SPECIFICATIONS
FEATURES & OPERATING CONTROLS
PRECAUTIONS &GENERAL INFORMATION
AGENCY APPROVAL INFORMATION
INSTALLATION
OPERATION
CLEANING INSTRUCTIONS
TROUBLESHOOTING
PARTS & SERVICE
CUSTOMER SERVICE DATA
xi
1
2
3
3
4
5
6
7
9
9
Proper installation, professional
operation and consistent
maintenance of this equipment
will ensure that it gives you the
very best performance and a long,
economical service life.
This manual contains the
information needed to properly
install this equipment, and to use
and care for the equipment in a
manner which will ensure its
optimum performance.
SPECIFICATIONS
DIMENSIONS:
12”H x 13-1/8”W x 9-1/16”D
1-1/8” x 5-1/4”
Cabinet
Bread Slot
Slices per Load
1
to 4
ELECTRICAL:
MODEL
T-4C
VOLTS
AMPS
kW
PLUG
208V
240V
11.5A
10.0A
2.4 kW
2.4 kW
NEMA 6-15P
NEMA 6-15P
T-4C 15A
BT-4C
120V
120V
15.0A
13.3A
1.8 kW
1.6 kW
NEMA 5-15P
NEMA 5-15P
1
FEATURES & OPERATING CONTROLS
ELEMENTS
(2 per slot,
8 total)
BREAD SLOTS
(4 total)
SLIDE
KNOBS
(1 per 2
slots,
BREAD GUIDES
(2 per slot,
8 total)
2 total)
SLIDE
RACKS
(1 per 2
slots,
DARKNESS
CONTROL
KNOBS
CARRY
HANDLES
(1 each side)
2 total)
(1 per 2
slots,
2 total)
INTERNAL COMPONENTS
CRUMB
TRAY
POWER
CORD
Fig. 1 Toaster Features & Operating Controls
n
BREAD SLOTS
One to four pieces of bread, one slice of bread per slot.
Oversized to accept Texas toast, English muffin, bagel, etc.
n
n
BREAD GUIDES
SLIDE RACKS
Hold bread at proper distance from elements
Carriages hold bread slices for toasting
Controlled by slide knobs
n
n
n
ELEMENTS
Provide toasting heat.
Note: Bagel toaster BT-4C toasts one side (cut side) only
One element in each pair is inert
DARKNESS
CONTROL
KNOBS
Individually adjustable from very light to very dark
Control time slide rack is down and elements are energized
Each knob controls one pair of bread slots
SLIDE KNOBS
Control slide racks. Initiate toasting timer when pushed
down. Each knob controls one slide rack (one pair of bread
slots)
n
n
POWER CORD
Plugs into appropriate electrical receptacle
CARRY HANDLESCarry the toaster here
DO NOT carry the toaster by the bread slots!
n
CRUMB TRAY
Crumbs accumulate here. Remove to dump crumbs
2
PRECAUTIONS AND GENERAL INFORMATION
This appliance is intended for use in commercial establishments
only.
This appliance is intended to prepare food for human consumption.
No other use is recommended or authorized by the manufacturer or its
agents.
WARNING:
Electric
Shock hazard
Operators of this appliance must be familiar with the appliance use,
limitations and associated restrictions. Operating instructions must be
read and understood by all persons using or installing this appliance.
All servicing requiring
access to non-insulated
electrical components
must be performed by a
qualified technician.
DO NOT open any
Cleanliness of this appliance is essential to good sanitation. Read and
follow all included cleaning instructions and schedules to ensure the
safety of the food product.
Unplug or disconnect the toaster from electrical power before
performing any maintenance or servicing.
access panel which
requires the use of tools.
Failure to follow this
warning can result in se-
vere electrical shock.
DO NOT submerge toaster in water. DO NOT splash or pour
water into bread slots, controls, control panel or wiring.
DO NOT lift or carry the toaster by the bread slots. Lift and carry
by the carrying handles only.
The technical content of this manual, including any wiring diagrams,
schematics, parts breakdown illustrations and/or adjustment
procedures, is intended for use by qualified technical personnel.
CAUTION:
Risk of
Damage
Any procedure which requires the use of tools must be performed by a
qualified technician.
DO NOT connect and/or
energize this appliance
until all installation
instructions are read and
followed. Damage to the
appliance will result if
these instructions are not
followed.
This manual is considered to be a permanent part of the appliance.
This manual and all supplied instructions, diagrams, schematics, parts
breakdown illustrations, notices and labels must remain with the
appliance if it is sold or moved to another location.
This appliance is made in the USA. Unless otherwise noted, this
appliance has American sizes on all hardware.
AGENCY APPROVAL INFORMATION
This unit complies with NSF standard 4 only if maintained and
operated per the instructions in this manual.
This unit is Underwriters Laboratory listed under E6070.
STD 4
E6070
3
INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
UNPACKING & INSPECTION
Carefully remove the toaster from the carton. Remove all
protective plastic film, packing materials and accessories from the
toaster before plugging the toaster into electrical power or otherwise
performing any installation procedure.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the toaster before starting any
installation.
Read and understand all labels and diagrams attached to the
toaster.
DO NOT lift or carry the
toaster by the bread slots.
This will damage the
heating elements Lift and
carry by the carrying
handles only.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
SETUP
Setup the toaster only on a firm level surface. Non-combustible
material (e.g. metal, terrazzo) is recommended.
CAUTION:
Electric Shock
Hazard
ELECTRICAL
The ground prong of the power
cord is part of a system
designed to protect you from
electric shock in the event of
internal damage to the
appliance.
NEVER CUT OFF THE
GROUND PRONG
(large round prong).
Refer to the nameplate. Verify the electrical service power. Voltage
and phase must match the nameplate specifications. Plugging the
toaster into the wrong voltage can severely damage the equipment or
cause noticeably decreased performance.
Your appliance is equipped with a grounded electric power cord. This
cord must be plugged into a properly grounded electrical receptacle.
T-4C Toasters are equipped with a 4 foot cord with grounded NEMA
6-15P plug. This cord must be plugged into a 208 or 240 volt, 15 amp
circuit with a properly installed and grounded NEMA 6-15R
receptacle. Refer to toaster nameplate for proper voltage.
NEVER TWIST A PRONG TO
FIT AN EXISTING
RECEPTACLE.
If circuit or receptacle does not
match the toaster plug, contact
a licensed electrician to install
an electrical receptacle
appropriate to the voltage and
amperage requirements of the
toaster.
T-4C 15A Toasters and BT-4C Bagel Toasters are equipped with a 4
foot cord with grounded NEMA 5-15P plug. This cord must be plugged
into a 120 volt, 15 amp circuit with a properly installed and grounded
NEMA 5-15R receptacle.
IMPORTANT:
Damage due to being plugged
into the wrong voltage or
phase is NOT covered by
warranty
4
OPERATION
GENERAL OPERATIONAL NOTES
CAUTION:
Hot Surface
Carefully read the description of the toaster operation on the
specification sheet.
Exposed surfaces
can be hot to the touch
and may cause burns.
DO NOT attempt to perform any maintenance or service, or attempt
to unjamb a slice of toast unless the toaster is unplugged from
electrical power.
DO unplug the toaster from electrical power before cleaning, servicing
or unjamming.
DO NOT use sharp objects or metal implements to unjamb a slice of
toast.
DO use a plastic spatula inserted along the bread guides, away from
the elements, to remove toast that is jammed.
DO NOT lift or carry the toaster by the bread slots. This will damage
the elements.
DO carry the toaster by the carry handles.
OPERATION
LIGHTER
Turn the darkness control knobs to the desired toast color. The knobs
may be rotated to the light position (fully counter-clockwise for very
little color) to the dark position (fully clock-wise for dark brown). There
are an infinite number of settings between these two extremes. Each
knob controls one pair of bread slots.
DARKER
Experiment with your normal bread product and adjust the darkness
control knobs to the desired toast color.
fig. 2 Darkness Control
Place one to four bread slices in the bread slots, one per slot. The
wide bread slots will accept other large size bread products, such as
buns, waffles, English Muffins, Texas-sized toast, etc. When using
non-standard bread products, be sure to adjust the darkness control
knob for your desired toast color.
Note: Model BT-4C Bagel
Toaster toasts only one side
(cut side) of bagels or buns.
Place bagels or buns in the
toaster in right or left pairs
of bread slots with cut sides
facing each other.
Press down on the slide knobs until they stop. The slide rack should
move easily, and catch in the down position. Each slide knob controls
one pair of bread slots (i.e. right or left pair).
Toast time is approximately two minutes (Model T-4C), two or more
minutes (Model BT-4C) or three minutes (Model T-4C 15A). These
times are only approximate and will vary depending on the darkness
setting. Your own experience with your product is your best guide to
the best darkness setting.
The slide rack raises automatically at the end of the timed cycle. Slide
racks may be manually raised at any time during the timed cycle by
lifting the slide knob.
Each successive toasting cycle will require less time as the toaster
chamber retains more heat. Adjust the darkness knob as required to
maintain your desired toast color.
5
CLEANING INSTRUCTIONS
CAUTION:
Electric Shock
Hazard
PREPARATION
Unplug toaster from electrical power before cleaning.
Allow toaster to cool completely before cleaning.
Unplug toaster from
electric power before
cleaning.
FREQUENCY
Daily
TOOLS
Soft Brush
CAUTION:
Burn Hazard
Clean Cloth or Sponge
Mild Detergent or Cleaner Formulated for Stainless Steel
Warm Water
Allow toaster to cool
completely before
cleaning.
CLEANING
Unplug toaster and allow to cool completely.
CAUTION:
Electric Shock
Hazard
With the slide knobs in the up position, wipe both slide racks with a soft
brush to remove any remaining food particles. DO NOT attempt to
brush or clean elements.
Do not submerge toaster
in water.
Remove the crumb tray. Empty the crumb tray and wipe with a clean
cloth moistened with clean warm water.
Wipe the outer portions of the toaster cabinet with a clean soft cloth or
sponge, warm water and a mild detergent or cleaner formulated for
cleaning stainless steel.
IMPORTANT: DO NOT spill
or pour water into bread slots,
slide slots or interior of
toaster.
Rinse by wiping toaster cabinet with a clean soft cloth or sponge
moistened with clean warm water.
IMPORTANT: DO NOT spill
or pour water into controls,
control panel or wiring.
Dry by wiping with a clean soft dry cloth.
DO NOT submerge toaster in
water. Damage to internal
components will occur.
Damage to internal
components from water
damage is not covered by
warranty.
6
TROUBLESHOOTING
SYMPTOM
POSSIBLE CAUSE
SUGGESTED REMEDY
Toaster won’t heat
Not plugged in, damaged plug or cord
or circuit breaker tripped
Check plug and cord
Check / reset circuit breaker
One or more sections
won’t heat
BT-4C Bagel Toaster
Bagel Toaster toasts only one
side of bagel or bun
Damaged element or other internal
component
Contact Authorized Wells
Service Agency for repairs
Slide knob won’t catch in
the down position
Latch contaminated with crumbs
Damaged internal components
Keep crumb tray clean
Contact Authorized Wells
Service Agency for repairs
Slide rack won’t raise at
end of toast time
Damaged internal components
Contact Authorized Wells
Service Agency for repairs
Toast or bagel too dark or
burnt
Darkness control set too dark
Damaged internal components
Adjust for desired darkness
Contact Authorized Wells
Service Agency for repairs
Toast or bagel too light
Darkness control set too light
Damaged internal components
Adjust for desired darkness
Contact Authorized Wells
Service Agency for repairs
NOTE: There are no user
serviceable components in the
toaster. In all cases of damage
or component malfunction,
contact your Authorized Wells
Service Agency for repairs.
7
THIS PAGE BLANK
8
PARTS & SERVICE
DESCRIPTION
SERVICE
PART NO.
IMPORTANT: Use only
factory authorized service
parts and replacement
TOASTER STAND
KNOB, DARKNESS CONTROL
KNOB, SLIDE
20931
60007
60008
60037
filters
.
For factory authorized
service, or to order factory
authorized replacement
parts, contact your Wells
authorized service agency,
or call:
CRUMB TRAY
Wells Manufacturing Co
.
2 Erik Circle
P. O. Box 280
Verdi, NV 89439
phone: (775) 345-0444
fax:
(888) 492-2783
(Service Parts Dept.)
Service Parts Department
can supply you with the
name and telephone
number of the WELLS
AUTHORIZED SERVICE
AGENCY nearest you.
CUSTOMER SERVICE DATA
please have this information available if calling for service
RESTAURANT _____________________________ LOCATION _____________
INSTALLATION DATE ________________________ TECHNICIAN ___________
SERVICE COMPANY ________________________________________________
ADDRESS ___________________________ STATE ______ ZIP__________
TELEPHONE NUMBER (_____)_____-_________
EQUIPMENT MODEL NO. _______________
EQUIPMENT SERIAL NO. _______________
VOLTAGE: (check one)
120
208
240
9
|